Fire safety

Our screen-printed products are NOT treated with a flame retardant.
Digitally printed banners made from 'Jetbanner' fabric are fire resistant.

HOWEVER:
If you specify in your request for a quotation or your order that your banners must be fire resistant, we will make sure they are treated with a flame retardant. This means that Faber Flags satisfies the most stringent European and international standards, including the German B-1 norm.
Read the section about the flame retardant treatment in the submenu and you will be safeguarded. We can also supply a certificate if this is required by the fire service. You must request this certificate with your order, as the issuing of a certificate is for specific orders only, and is therefore not done as standard.

If you forget to order the flame retardant treatment from us in advance, or if some of your products need to be fire resistant, you must organise this yourself and this treatment falls outside the scope of our responsibility. There is a special fire-retardant impregnating agent on the market that you can use to treat your street banners; it is available at: http://www.flamelock.nl

Advice:
If you intend to carry out the impregnation yourself, use an agent that is suitable for polyester or synthetic fabrics. Make sure you use the prescribed amount. If the spray can is intended for a 2 m² area, for example, you should not use the content of just 1 can to treat a 100 x 300 cm banner. In such a case, the treatment would not be adequate. Once again, these activities are not the responsibility of Faber Flags.